Publish Time: 2021-09-15 Origin: Site
The fabric die cutting machine is specially designed for the garment industry and the cutting of plush fabrics. It can accurately cut a variety of garment fabrics with any graphics. It can be equipped with a feeding device to realize continuous automatic cutting of roll materials. So how much do you know about the fabric die cutting machine?
Here is the content list:
1.How does the fabric die cutting machine work?
2.What are the advantages of the fabric die cutting machine?
3.What are the rules to follow when using the fabric die cutting machine?
The fabric die cutting machine is equipped with sealed smoking, marking, and cutting of the garment pieces at one time, and exhausts the smoke generated during cutting through negative pressure. Negative pressure absorption and crawler transfer worktables make it convenient and quick to receive and feed materials. The cutting fabrics include various materials such as plush fabrics, non-woven fabrics, cotton and linen, chemical fibers, and so on. The fabric die cutting machine can be used with the clothing photocopying machine to quickly produce samples.
The dust-free non-woven fabric processed by the fabric die cutting machine does not turn yellow, automatically closes the edges, does not fray, does not deform, does not become hard, the size is consistent and accurate; there is no burr, the size is standard, and the error is small (±1mm), The effect is soft, without the harshness of high frequency or die-cutting pressure. It can cut any complicated shape; high efficiency, low cost, computer-designed graphics, can cut laces of any shape and any size. Due to the combination of computer technology, users can realize laser engraving output as long as they design on the computer and can change the engraving at any time, and they can design and produce products.
1. Operators must be trained to be familiar with the structure and performance of the equipment and to master the knowledge of the operating system.
2. When the fabric die cutting machine is started, the operator is not allowed to leave the post or be taken care of without authorization. If it is necessary to leave, the operator should stop the machine or cut off the power switch.
3. When an abnormality is found during the processing, the fabric die cutting machine should be shut down immediately, and the fault should be eliminated or reported to the supervisor in time.
4. When using gas cylinders, avoid crushing the welding wires to avoid leakage accidents. The use and transportation of gas cylinders should comply with gas cylinder supervision regulations. It is forbidden to explode the gas cylinder in the sun or close to a heat source. When opening the bottle valve, the operator must stand on the side of the bottle's mouth.
5. Observe the high-voltage safety regulations when repairing. Every 40 hours of operation or weekly maintenance, every 1,000 hours of operation, or every six months of maintenance shall be carried out by regulations and procedures.
6. After turning on the fabric die cutting machine, manually start the machine in the X and Y directions at low speed, and check whether there is any abnormality.
7. After inputting the new part program, test runs it first and check its operation.
8. When working, pay attention to the operation of the machine tool to avoid accidents caused by the fabric die cutting machine going out of the effective stroke range or two collisions.
It is the responsibility of each manufacturer to produce a fabric die cutting machine that meets the standards, to ensure the healthy development of the fabric die cutting machine market. Wuhan TIMING Weiye Technology Co., Ltd. conducts many tests on fabric die cutting machines before they leave the factory, and the quality qualification rate is guaranteed. If you are in the fabric die cutting machine business, you can consider our cost-effective products.