Publish Time: 2022-01-06 Origin: Site
We all know that the automatic fabric spreading and cutting machine is a large-scale operating machine, so there are a series of operating procedures in the process of using the automatic fabric spreading and cutting machine, so what is the specification for the use of the automatic fabric spreading and cutting machine? Let's go take a look next.
This is the content list:
l Operating procedures
l Precautions
Turn on the air pump switch of the automatic fabric spreading and cutting machine, turn on the air source of the automatic fabric spreading and cutting machine, pull up the manual air pressure switch on the left side of the automatic fabric spreading and cutting machine operation table, and raise the pressure roller of the automatic fabric spreading and cutting machine. Place the composite finished carpet material under the cloth pressing roller of the automatic fabric spreading and cutting machine, press the manual air pressure switch on the left side of the operation table of the automatic fabric spreading and cutting machine, and the cloth pressing roller will descend to press the carpet material. Note that your hands should be placed outside the fabric of the automatic fabric spreading and cutting machine to avoid crushing your fingers. Set the motorized/manual switch on the operation table of the automatic fabric spreading and cutting machine to the manual position, turn on the power of the automatic fabric spreading and cutting machine, and adjust the knob of the inverter on the left side of the operation table of the automatic fabric spreading and cutting machine to automatically spread the cloth and cutting machine. The value is adjusted to around 18---20HZ, adjust the knob of the inverter on the right side of the operation table of the automatic fabric spreading and cutting machine, and adjust its value to about 2.45---2.55HZ. Adjust the light control on the conveyor frame of the automatic fabric spreading and cutting machine to the corresponding electric blanket size specification. Open the cabinet door under the operating table of the automatic fabric spreading and cutting machine, there are three-phase and single-phase switches inside, and close the switches, and the automatic fabric spreading and cutting machine starts to operate. To ensure that the pattern of the blanket material is parallel to the cloth pressing roller, the cutting knife slot of the automatic fabric spreading and cutting machine, pay attention to the automatic fabric spreading and cutting machine to observe the running track of the carpet material, and run to the cutting edge of the left side of the cutting groove at the pattern, Quickly turn the manual switch to the motorized position, and the automatic fabric spreading and cutting machine starts to run automatically. The operator should always pay attention to the automatic fabric spreading and cutting machine to observe the size of the cut blanket material and the cutting position of the blanket material.
Check once a week whether the shell of the automatic fabric spreading and cutting machine is well-grounded. Check whether the blade of the automatic fabric spreading and cutting machine is sharp every day. If it is not sharp, use a grinding stone to grind it. Check whether the air circuit of the automatic fabric spreading and cutting machine is leaking every day. The circuit of the automatic fabric spreading and cutting machine is checked once a month to keep the insulation in good condition. The reducer of the automatic fabric spreading and cutting machine should be replaced with lubricating oil every six months. After the motor of the automatic fabric spreading and cutting machine is used for one year, the grease should be replaced. The chain of the automatic fabric spreading and cutting machine should be kept normally lubricated and tensioned in time. Grease once a week between the gears and worm gears of the transmission automatic fabric spreading and cutting machine. When the automatic fabric spreading and cutting machine is not used for a long time, pay attention to moisture and rodent prevention. The work should promptly clean up the dirt sticking to the pressure roller of the automatic fabric spreading and cutting machine, so as not to make it difficult to clean for a long time. Carefully clean up after getting off work every day to ensure the smooth operation of the automatic fabric spreading and cutting machine.
Wuhan TIMING Weiye Technology Co., Ltd. is the newest industrial company. To produce a better automatic fabric spreading and cutting machine, the operation process and precautions of the automatic fabric spreading and cutting machine are described to the extreme. If you are interested in the automatic fabric spreading and cutting machine, please contact us. Our website is https://www.timingcutter.com/.